– 23 –
ENGLISH
6-4. Paper Guide Adjustment
When the printer is shipped from the factory, the paper guides and upper guides
are adjusted for roll paper with the following width.
Paper width: 79.5 ± 0.5 mm (TSP1043)
Paper width: 82.5 ± 0.5 mm (TSP1045)
When using roll paper with a width other than listed above, perform the following
procedure to adjust the paper guides. To adjust the upper guides, refer to “6-5
Upper Guide Adjustment”.
(1)Loosen the four screws.
(2)Adjust the left and right paper guides according to the width of the roll paper,
making sure to leave approximately 0.5 mm of space between each guide and
the edge of the paper.
The scales on the metal plate inside the printer are divided into 1 mm segments
between the marks. The two marks above the scales are used for 57.5 mm
wide paper and the two marks are used for 79.5 mm wide paper. Accord-
ingly, for roll paper with a width of 79.5 mm, position each paper guide 0.5
mm to the outside of the respective mark. If necessary, screws 2 and 3 can
be removed and installed in the adjacent screw holes.
(3)Tighten the four screws.
Screw 1 Screw 2
Screw 4
Screw 3
Left paper guide Right paper guide