5cm maximum
Fastener
Pull and cut
(2)Pass the fastener through the ferrite core.
(3)Loop the fastener around the cable and lock it. Use scissors to cut off any excess.
(4)Plug one end of the modular cable into the modular jack of the periph- eral.
(5)Remove the modular jack cover from the back of the printer and plug the other end of the modular cable into the jack of the printer.
ENGLISH
Note: Before connecting/disconnecting the peripheral drive cable, make sure that power to the printer and all the devices connected to the printer is turned off. Also make sure the power cable plug is discon- nected from the AC outlet.
(1)Connect the peripheral drive cable to the connector on the rear panel of the printer.
– 7 –
