ENGLISH
6. Near-end Sensor
This printer is equipped with a sensor that detects when a roll of paper is near the end. Read the following if you are going to use this sensor.
(1)Pull the lever in the direction indicated on it, and then open the printer cover.
(2)Loosen the two sensor fixing screws.
(3)Slide the sensor unit up or down, and then adequately tighten its screws. The following table shows the diameter of the paper that would remain on the roll in order for the sensor, installed at the specified sensor fixing screw position, to detect it.
Sensor fixing screws
(Level 1)
ø18 mm
ø12 mm | A |
Roll paper core | A |
|
– 14 –
