Star Micronics XR-1000 1Set iustification, mode, Produce character space, Select, Both, Standard

1Set iustification		mode	Both 1
1 cESC>	a	cn>	I

1Bh61hCTD

2197<n>

The command above will set the justification mode in which the printer prints received data, where 01> is a binary or ASCII value in the range OOh(or W”) through

02h (or “2”). The meanings of these values are shown in the table below:

Value Meaning

ooh. “0” Left justification

Olh. “1” 1 centering

02h. “2” I Right justification

The default (when the printer is first turned on) is left justification.

1 Produce character space			Standard 1
I &SC>	<SP>	Cn>	I
1Bh	20h	Cn>
27	32	cn>

‘Ihe command above produces a space character, where <SF5 is the ASCII space character (20h), and 01> is a binary value from 0 through 127 giving the space width in dots. When in draft mode, the dot spacing is l/120 inch, and when in NLQ, the dot spacing is l/240 inch. If in superscript or subscript printing, the dot spacing is the same as above, but if in expanded mode, the resolution is half the above.

Select	next horizontal print position (by dot)			Both
<ESC>	$	cnO>	cd>
1Bh	24h	dh	cd>
27	36	alo>	cd>

The command above will start subsequent printing at a horizontal position deter- mined by dot spacing, where ore> and al> are two binary numbers (low byte first) specifying the number of dots (at l/60 inch spacing) by which the print head will move to the right from the left margin. If the subsequent print position is beyond the right margin, then printing will start at the left margin.

47