STEP #1 - UNPACK AND ASSEMBLE MAIN FRAME:
1.Remove and unwrap all product from shipping boxes. Lay all parts out in a clean open area to prepare for assembly.
2.Locate the MAIN FRAME, SIDE FRAME LEFT and SIDE FRAME RIGHT as shown below.
3.As shown slide SIDE FRAME LEFT into MAIN FRAME. At each tube loosely Install three (M8 X 25MM, BUTTON HEAD BOLTS), and three (M8, FLAT WASHERS) do not tighten at this time.
4.As shown slide SIDE FRAME RIGHT into MAIN FRAME. At each tube joint loosely Install three (M8 X 25MM, BUTTON HEAD BOLTS), and three (M8, FLAT WASHERS) do not tighten at this time.
5.Using a 5MM hex key tighten all the (Button HEAD BOLTS) to specified torque setting. NOTE: each tube joint has three bolts, one located on top, bottom, and side.
STEP #1 Completed
Page 12
