Star Trac Pro Upright Bike Install the Seat Post, Install the Display Console, Install the Pedals

3. Install the Seat Post

Carefully slide the seat post into the seat tube.

Pull out on the seat release knob, and slide the seat post fully into the seat tube. Release the seat release knob.

Install two M4 X 20 socket head screws into the seat sleeve to secure it. Tighten the screws securely using the 3mm hex wrench.

Install the M6 X 10 socket head screw into the hole in the back of the seat tube. Using the 4mm hex wrench, tighten the screw securely.

Step 3

4. Install the Display Console

NOTE: It may be necessary to have one person support and posi- tion the display console while a second person makes the cable connection.

Carefully slide the display console neck approximately one inch onto the neck brackets of the bike frame. With the console partial- ly supported by the neck brackets, plug the display console cable into the receptacle on the bike frame.

Step 4A

CAUTION: Be careful not to pinch your fingers between the console neck and the bike frame when sliding the console into place.

CAUTION: Be sure not to pinch the display cable between the con- sole neck and the bike frame.

Carefully slide the console neck onto the neck brackets until it is fully seated. Secure the display console to the frame with four M6 X 16 flat head screws (two screws in front side and two screws in back side). Using the 4mm hex wrench, tighten all four screws securely.

Step 4B

5. Install the Pedals

Install the pedals on the pedal cranks using a 5/8-inch open-end wrench. Tighten the pedals securely.

NOTE: Turn the left pedal spindle counterclockwise when thread- ing into the crank arm; turn the right pedal spindle clockwise when threading into the crank arm.

Step 5

12 STAR TRAC PRO BIKES OWNER’S GUIDE