State Industries GSX, GS6, GPX manual Water Hammer, General, Effects, Fix

BULLETIN 11

WATER HAMMER

GENERAL

Water hammer is the destructive force, pounding noise and vibration in a piping system when water flowing through a pipeline is stopped abruptly. When water hammer occurs, a high intensity pressure wave travels back through the piping system until it reaches a point of some relief. The shock wave will then surge back and forth between the point of relief and the point of stoppage until the destructive energy is dissipated in the piping system. The violent action accounts for “banging”, “thumping”, and/or intense vibration in the pipe line. Although noise is generally associated with the occurrence of water hammer, it can occur without audible sound or noise. Quick closure of valves always causes some degree of shock with or without noise. The common cause of water hammer is single lever faucets (sinks/lavatories) or automatic solenoid valves dishwashers, washing machines, etc.). The speed of the valve closure time is directly related to the intensity of the surge pressure.

EFFECTS

The damage from water hammer can manifest itself in a number of ways. The most common are:

•Expanded Tank Shell - This can be demonstrated by measuring the circumference at various locations along the shell. Pressures in excess of the maximum design working pressure can cause permanent deformation of the shell. NOTE: The continuous expansion of the tank shell may cause the tank to rupture at a welded seam.

•Collapsed Flue Tube - This will choke off the ability to vent the products of combustion causing the flame and/or combustion to spill out from the combustion chamber. Often this will occur where thinning of the flue tube walls has occurred due to contamination of the combustion air or because of excessive condensation.

•Inverted or Deformed Tank Heads - Often this accompanies collapsed flues, but one or both heads can be deformed.

THE FIX	The only effective means of control is to install water hammer arrestors. These
	devices have diaphragms which separate an air chamber from the water in the
	piping system. As the shock wave reaches this device, the air chamber absorbs the
	shock. Arrestors should be located as close as possible to the source of the shock
	wave.
NOTES	Since water hammer exposes the equipment to pressures in excess of its design
	limits, failures caused by water hammer are not eligible for warranty consideration.

27