
MSE 140 C, MSE 160 C,
MSE 180 C
1
100BA029 KN
:Wait for the overload circuit breaker to cool down.
:Press in button (1) as far as stop. If the motor does not start when you switch on, you can assume that the overload circuit breaker has not cooled down sufficiently. Wait a little longer and then press the button again as far as stop.
Once the motor starts:
:Run your saw for about 15 seconds
MSE 200 C
1
100BA030 KN
Model MSE 200 C is equipped with an electronic overload circuit breaker which measures motor temperature and current drawn.
:The LED indicator (1) comes on in case of overload and the power supply is interrupted. The indicator goes off after about 2 seconds and the saw is ready for operation.
:Run your saw for about 15 seconds
Note that the overload indicator glows only as long as the trigger switch is activated.
English / USA
Operating Instructions
During operation
:Check level in chain oil tank.
:Fill up with fresh chain oil when the level reaches the "min" mark - see "Filling Chain Oil Tank".
:Start cutting with the saw chain running.
:Always cut with a properly sharpened chain and apply only moderate feed pressure. The sound and running behavior of the saw must remain constant. The motor speed may only drop a little in the cut – the chain must not jerk or stop.
:If motor noise drops suddenly or the chain stops, reduce feed pressure immediately to avoid overheating and possible damage to the saw.
MSE 140 C, MSE 160 C, MSE 180 C, MSE 200 C | 33 |