English / USA

689BA044 KN

689BA052 KN

RSC3, RMC3, PMC3, PMMC3:

The upper part of the humped drive link (with service marking) is lowered along with the depth gauge.

The other parts of the triple-humped tie strap and humped drive link must not be filed since this may increase the kickback tendency of the chainsaw.

:File the top of the depth gauge parallel to the stamped service marking (see arrow) – but do not lower the highest point of the depth gauge in this process.

The kickback tendency of the chainsaw is increased if the depth gauges are too low.

:Place filing gauge on the chain – highest point of depth gauge must be level with the filing gauge.

PM 1, RM2:

Rear hump of tie strap (with service marking) is lowered along with the depth gauge.

:After sharpening, clean the chain thoroughly, remove filings or grinding dust – lubricate the chain thoroughly.

:Before long out-of-service period, clean the chain and store it in a well-oiled condition.

Sharpening Tools (special accessories)

 

 

Flat file1)

Sharpening kit2)

Chain pitch

 

Round file Ø

Round file

File holder

Filing gauge

inch

(mm)

mm

(inch)

Part No.

Part No.

Part No.

Part No.

Part No.

1/4

 

(6.35)

4.0

(5/32)

5605 772 4006

5605 750 4327

1110 893 4000

0814 252 3356

5605 007 1027

3/8

PMN

(9.32)

4.0

(5/32)

5605 772 4006

5605 750 4327

0000 893 4000

0814 252 3356

5605 007 1026

3/8

P

(9.32)

4.0

(5/32)

5605 772 4006

5605 750 4327

1110 893 4000

0814 252 3356

5605 007 1027

0.325

(8.25)

4.8

(3/16)

5605 772 4806

5605 750 4328

1110 893 4000

0814 252 3356

5605 007 1028

3/

8

 

(9.32)

5.2

(13/ )

5605 772 5206

5605 750 4329

1110 893 4000

0814 252 3356

5605 007 1029

 

 

 

 

64

 

 

 

 

 

1)Use triangular file 0811 421 8971 for PM1 and RM2

2)consisting of file holder with round file, flat file and filing gauge

40

MSE 140 C, MSE 160 C, MSE 180 C, MSE 200 C