SERVICING INSTRUCTIONS
REPLACING PARTS
1.GENERAL
1.1All principal components can be replaced without removing the stove from its installation, although it is essential that the gas supply to the appliance is turned off at the isolation device before proceeding further.
1.2If, for any reason, the flue has to be removed from the stove, the seals must be replaced.
2.MAIN BURNER
2.1Turn the gas supply off at the isolation device, remove the door and place to one side, carefully remove the ceramic fuel bed components.
2.2Remove the three securing screws, two at the rear and one at the front left hand side. See diagram 1. Raise the left hand side of the burner to clear the bracket, draw the left hand side forward. The burner venturi is engaged over the injector. When removing the burner be sure to clear the injector, this will release the right hand side of the burner. Take care when removing the burner so as not to damage the pilot burner.
1
AR1605
2.3To replace the burner, engage the venturi over the injector ensuring the burner sits on top of the fixing bracket. Push the burner to the right and whilst holding, insert the three fixing screws.
NOTE: BEFORE REPLACING THE BURNER, ENSURE THE SILICONE SEAL AROUND THE INJECTOR IS INTACT AND CHECK THAT VENTURI COVER IS ATTACHED.
3. PILOT UNIT
The pilot assembly consists of five components, which can be individually changed, these are:
1)Pilot burner bracket
2)Pilot injector
3)Electrode
4)Thermocouple
5)Gasket.
3.1Turn the gas supply off at the isolation device, remove the door and place to one side, carefully remove the ceramic fuel bed components
3.2Refer to Section 2 to remove the main burner. Remove the thermocouple baffle taking note of how it is positioned. Refer to Diagram 2
2
AR1609
3.3Remove the two fixing screws from the pilot bracket, see diagram 3. Gently draw the assemble away from the firebox to give access to the nuts and ignition lead.
NOTE: TAKE CARE NOT TO DAMAGE THE GASKET.
3
AR0614
22
