USER INSTRUCTIONS
7.4Place log D across from the rear log A to log B on the left- hand side. There are
5
AR1613
7.5There are two ash panels which lay across the front of the burner skin. Place the panel with the flat edge facing the left side of the firebox. There are location holes on this log which fit over the screw holes of the burner skin.
6
AR1614
7.6Place the second ash panel to the right of the first, with the pointed end of the panel fitting into the V shape. This panel should locate on the screw holes of the burner skin. Ensure that both logs are horizontal to the burner ports.
7
AR1615
7.7Place log E across from the rear of log A to log C on the right hand side. Again, there are
8
AR1616
7.8Ensure that the fibreglass seal on the back of the door is intact, locate the door on the four studs and slide back to the firebox. Secure in place using the four dome nuts and tool supplied. Do not overtigthen the nuts.
NEVER OPERATE THE STOVE WHEN THE DOOR IS REMOVED.
8.THE FLAME FAILURE DEVICE
8.1This is a safety feature incorporated in all GAZCO fires which automatically switches off the gas supply if the pilot light goes out and fails to heat the thermocouple.
9.‘RUNNING IN’
9.1The surface coating on your GAZCO fires will "burn off" during the first 24 hour of use, producing a harmless and temporary odour. This will disappear after the short period of use. If the odour persists, ask your installer for advice.
10.SERVICING
10.1The fire must be serviced every 12 months by a qualified Gas Engineer. In all correspondence, always quote the appliance type and serial number, which may be found on the data badge.
11.INSTALLATION DETAILS
11.1To assist in any future correspondence, your installer should have completed the commissioning sheet at the front of this manual. This records the essential installation details of this appliance. In all correspondence always quote the Model No. and Serial No.
6
