USER INSTRUCTIONS
5. HANDLING & DISPOSAL OF FIRE CERAMICS
5.1The fuel effect and side panels in this appliance are made from Refractory Ceramic Fibre (RCF), a material which is commonly used for this application.
5.2Protective clothing is not required when handling these articles, but we recommend you follow normal hygiene rules of not smoking, eating or drinking in the work area and always wash your hands before eating or drinking.
5.3To ensure that the release of RCF fibres are kept to a minimum, during installation and servicing a HEPA filtered vacuum is recommended to remove any dust accumulated in and around the appliance before and after working on it. When servicing the appliance it is recommended that the replaced items are not broken up, but are sealed within heavy duty polythene bags and labelled as RCF waste.
5.4RCF waste is classed as stable,
5.5Excessive exposure to these materials may cause temporary irritation to eyes, skin and respiratory tract; wash hands thoroughly after handling the material.
6.CLEANING THE FIRE
6.1Only clean the stove when it is cold.
6.2Remove the four black nuts retaining the door. Take care when removing the door as it is heavy.
6.3Remove all of the ceramic logs, being especialy careful handling the front ash panels.
6.4The logs should not require cleaning. Do not use a vacuum cleaner or brush to clean the logs, any large pieces of debris may be removed by hand.
6.5Ensure any debris is removed from the burner ports.
6.6Replace the ceramics and door referring to section 7.
6.7Use a damp cloth to clean the outer casing of the appliance.
7.FUEL BED ARRANGEMENTS
Remove the cast iron door using the tool provided. Remove the front coal retainer by lifting vertically.
NOTE: THE CAST IRON DOOR IS HEAVY, TAKE EXTREME CARE WHEN HANDLING TO AVOID DAMAGING THE OUTER CASING.
The fuel bed consists of 5 logs and 2 ash panels. The logs have letters A,B,C,D and E moulded into them for identification.
7.1Take the rear log A and place it up against the rear of the fire sitting on the two flat ledges of the burner. The two legs of the log should sit between the rear burner ports. See diagram 2. Ensure there is an equal gap between each side of the log and the side of the firebox.
2
AR1610
7.2Place log B on the left hand side of the burner with the location bar on the underside of the log fully located in the long slot of the burner. Make sure the log is as far to the left as possible. See diagram 3.
3
AR1611
7.3Place log C on the right hand side of the burner with the location bar on the underside of the log fully located in the long slot in the burner. Make sure the log is as far right as possible. See diagram 4.
4
AR1612
5
