Stovax Medium Wood & Multi-fuel manual Removal Of The Log Guard, Removal Of Fire Bricks

MAINTENANCE and SERVICING

1.4Using the appliance for the first time:

•Burn at a low output for the first day of use

This allows the seals, fixing glues and paint to fully cure.

1.5During this time the appliance may give off some unpleasant odours:

• Keep the room well ventilated to avoid a build-up of fumes.

1.6Your Stovax dealer can carry out service and maintenance.

2.REMOVAL OF THE LOG GUARD

2.1See Section 4, Installation Instructions, to remove and replace the log guard:

3.REMOVAL OF FIRE BRICKS

3.1See Section 5, Installation Instructions, to remove and replace fire bricks

4.FITTING AND REMOVAL OF BAFFLE

4.1See Section 6, Installation Instructions, to remove and replace the baffles.

5.REMOVAL OF MULTI-FUEL GRATE

5.1See Section 5, Installation Instructions, to remove and replace the multi-fuel grate.

6.REMOVAL OF WOOD BURNING TRAY

6.1See Section 7, Installation Instructions, to remove and replace the wood burning tray.

7.FITTING A NEW DOOR GLASS ALL MODELS

Door Rope Seal

Fixing Screw

Glass Clamp

Glass

Glass Edge Seal Tape

Door Cross

Door

PR8078

7.1To maintain the safe use of your stove you may need to replace a damaged door glass. To complete this operation:

•Lift the door free of the hinge blocks on the right of the single door or both side for the double door

•Lie the door on a soft flat surface, to protect the glass and the paintwork

•Use a 2.5mm A/F hexagon key to remove the exposed fixing screws in the glass clamp, see Diagram

The old glass can then be lifted clear of the door. (Note how the edge sealing tape is fixed.) Remember to dispose of the old glass safely.

•Clean, and re-paint, the rear of the door if required

•Clean the screws with light oil or WD40® to aid future removal

•Fit the edge sealing tape to the new glass

•Place the glass into position in the door

•Place the door glass clamp back in to position and re-fix with the clean fixing screws

7.2Fit only Stovax Ceramic Glass, which is suitable to use in high temperature applications.

7.3Using the appliance with a damaged door glass could cause dangerous fumes to enter the room, or the stove to over fire, resulting in damage.

8.Fitting a new door seal

ALL MODELS

8.1To maintain the safe use of your appliance you need to replace damaged or worn door sealing rope. To complete this operation:

•Remove the door from the appliance, by opening, removing the hinge pins and lifting the door free of the hinge blocks

•Lay the door face down on a soft flat surface, to protect the paintwork and glass

•Remove the old rope and scrape old glue from the locating groove

Clean the locating groove with a clean dry cloth to remove all old dust and debris.

•Squeeze a generous bead of fresh Stovax Thermic Seal glue into the rope locating groove

27