Stovax Large Wood & Multi-fuel manual Pre-Installationchecks, Flue, Additional Ventilation

PRE-INSTALLATION CHECKS

1. Flue

MODEL:			TraditionalSmall SMM/RVP-SMW	TraditionalLarge LAM/RVP-LAW
Riva Plus Small RVP-SMM/RVP-SMW
Riva Plus Large RVP-LAM/RVP-LAW
			Riva RVP-	Riva RVP-
	Without flue liner Round (diameter)	mm	150	150
		inch	6	6
	Without flue liner system Square	mm	135	135
		inch	51/2	51/2
Flue/Chimney Size	(diameter)
	With liner or Factory made system	mm	†150	†150
	(diameter)
	installed in accordance with manufacturer's instructions	inch	†6	†6
Flue/Chimney	All products	metre	4.5	4.5
		feet	13	13
(*minimum height)

* When measured from the top of the stove to the top of the flue, with no horizontal sections and a maximum of 4 bends with angles of less than 45o

†May be 125mm (5") if only burning low volatiles (smokeless) fuels approved for use in Smoke Control Areas.

See website http://uksmokecontrolareas.co.uk for more information about approved fueld

2. ADDITIONAL VENTILATION

2.1Additional ventilation is required to comply with the requirements of the Building Regulations. This must be provided using a permanently open air vent, of the size listed, which is positioned so that it is not liable to be blocked both inside and outside the building.

2.2Extractor fans or cooker hoods must not be placed in the same room or space as this can cause the appliance to emit fumes into the room.

2.3If any of these checks reveal problems do not proceed with the fitting of the appliance until they have been rectified.

MODEL:		Traditional Small SMM/RVP-SMW	Traditional Large LAM/RVP-LAW
Riva Plus Small RVP-SMM/RVP-SMW
Riva Plus Large RVP-LAM/RVP-LAW
		Riva RVP-	Riva RVP-
	mm2	NONE	3300
Additional Ventilation	cm2	NONE	33.0
	in2	NONE	5.12

17