STOW CS4030 SAW — WATER DELIVERY SYSTEMS
Installing the Flange Guard
The Flange Guard protects the Blade Flange not in use.
1.Slide the Flange Guard onto the Guard Mounting Tab on the frame. (See Figure 19.)
2. Verify that the Blade Flange not in use is secured to the Blade Shaft, by tightening the mounting bolt.
1
3
2
Figure 19.The Flange Guard Installed
Water Delivery System (Option)
CAUTION
When storing the saw where temperatures may drop below freezing, blow out the water lines to prevent damage to the water delivery system.
1.Connect the water supply hose to the water inlet (garden hose) fitting on the left side of the saw, (Item 20, Figure 4).
2. Verify that the water hose on the saw is connected to the Blade Guard, (Figure 15), and that the water hoses or tubes are pointed into both Blade Flanges.
Figure 20. Optional Bladeguard Water Tube
5.The lever on the left side of the control panel regulates water flow volume.The lever on the right side of the control panel turns the water ON and OFF.
6.If the saw is equipped with an optional water pump, the ON/OFF switch is located on the control panel next to the water ON/OFF control valve.
Ensure that the hose ends maintain a 45o angle and maintain a light contact with the surface of the blade.
3.Ensure that the hose ends maintain a 45o angle and maintain a light contact with the surface of the blade. (Figure 18.)
PAGE 30 — STOW CS4030 SAW • OPERATION MANUAL — REV. #0 (12/13/07)
