![](/images/new-backgrounds/1209511/20951175x1.webp)
STOW CS4030 SAW — LOADING AND TRANSPORTING
LOADING/UNLOADING ANDTRANSPORTINGTHE SAW | Lifting Point | |
Loading and Unloading | The convenient single point for lifting the saw with a hoist is | |
located above the engine. (Figure 35.) | ||
|
WARNING
When LOADING, UNLOADING, or when on a STEEP SLOPE, the engine MUST BE at 1800 RPM or above to prevent loss of control.
|
|
The saw is provided with holes at each corner of the lower frame | Figure 35. Lifting Point |
for easy |
CAUTION
NEVER tie the back end of the saw down by strapping across the handlebars.
CAUTION
The use of
WARNING
AVOID INJURY!
Stay clear of the saw while it is being hoisted.
To avoid possible damage to the saw, use approved rigging (minimum 3000 lb. test) when hoisting the saw.
Night Light
The night light, (Figure 36),can be used on either side of the saw and can be extended and rotated for best illumination of the cutting area. Aim the light then lock it in position by tightening the lock knobs. The light can be removed for storage by loosening the lock knobs, disconnecting the light cord and sliding the light bar out of the saw.
To turn Lights ON, push the
Figure 34. Tie-Down Points
Figure 36. Night Light
PAGE 38 — STOW CS4030 SAW • OPERATION MANUAL — REV. #0 (12/13/07)