Stow cs403030, cs403026, cs403020 Stow CS4030 SAW Bladeshaft Engage System, Setting the Depth Stop

STOW CS4030 SAW — BLADESHAFT ENGAGE SYSTEM

Setting the Depth Stop

The CS4030 saw uses a controlled Depth Stop to position and set the blade at a desired cut depth. (Figure 29.)

To Control the Depth of Cut with saw running and Blade Mounted:

1.Set Depth Indicator as outlined on previous page.

2.Loosen pointer knob, (Item 1, Figure 30).

3.Rotate pointer to desired depth, (Item 2, Figure 30).

4.Re-tighten pointer knob to lock-in cutting depth.

2

Figure 29. Depth Stop

If a blade is changed for any reason, or if wear is suspected sincethe lasttimedepthstopwas

NOTEset, you will need to re-set the depthstop. Ifacutataprecisedepth is necessary, it is best to make a pre- cut and MEASURE at deepest part ofcuttoconfirmcutisatdesireddepth.

1

1.Depth Control Knob

2.Depth Indicator Pointer

Figure 30. Indicator and Depth Control Knob

WARNING

Always adhere to manufacturer's blade speed recommendations for Surface Feet Per Minute when choosing a blade for your cutting conditions. See blade size/speed information, "Blade RPM vs. Surface Feet Per Minute (SFPM) on page 24.

STOW CS4030 SAW • OPERATION MANUAL — REV. #0 (12/13/07) — PAGE 35