Battery Setup
WARNING
Flammable, explosive gas. (produces hydrogen gas while charging or during operation). Keep area around battery well ventilated and keep from any fire source.
Battery electrolyte contains corrosive, toxic chemical. (dilute sulfuric acid). Avoid contact with eyes and skin.
STOW CS4030 SAW — BATTERY
Figure 21. Battery and Battery Box
WARNING
Shock or Fire due to electric short- circuit. Disconnect battery cables before inspecting electrical system and never "spark" battery terminals to test for charge.
CAUTION
Use all safety precautions specified by the battery manufacturer when working with the battery. See further specific safety information on page 18 of this manual.
This saw was shipped with a wet charged battery, (Figure 21). This battery may need to be charged for a brief period of time as per the manufacturer instructions.
To install the battery on the saw, make sure that the battery is properly clamped into the battery box. Connect the positive cable to the positive terminal on the battery first, then connect the negative cable to the negative terminal.
The STOW CS4030 Saw uses 2 positive battery cables and 2
NOTEnegative battery cables. One set is for the starter on the engine and the other set is for the raise/lower pump assembly. Make sure that both sets ofcablesareconnectedtothebattery.
STOW CS4030 SAW • OPERATION MANUAL — REV. #0 (12/13/07) — PAGE 31
