Stow cs403026, cs 403016, cs403020, cs403030 Blade Flange Puller Removing the Inner Blade Flange

STOW CS4030 SAW — MAINTENANCE

3.Lock down the Wheel Mount Assembly Attachment Bolts when the appropriate alignment distance is set.

1

2

3

1.PivotAttachmentBolt

2.AdjustmentAttachmentBolts

3.AdjustmentScrew

Figure 54. Drive Wheel Alignment Bolt

Locations

Blade Flange Removal/Installation

Correct removal or installation of the Inner Blade Flange requires Flange Puller (p/n 18503) as shown in figure 55.

WARNING

If unfamilar with this operation seek assistance or training from someone that is familar with this operation. Because of the tapered fit between the Blade Flange and Blade Shaft, 5-10 tons of force is required to release the inner flange from the Blade Shaft. Both parts and tools can become dangerous projectiles if instructions are not followed properly.

4

2 5

13

1.Blade Flange

2.Horseshoe Puller Plate

3.Puller Plate

4.PerimeterBolt

5.Center Puller Bolt

Figure 55. Blade Flange Puller

Removing the Inner Blade Flange

1.With the Outer Blade Flange in place, loosen the Blade Mounting Bolt approximately 1/4".

WARNING

The Outer Flange MUST be in place to prevent the Puller assembly and Inner Flange from flying off when the taper breaks loose. Injury or equipment damage could otherwise result.

2.While the 3 perimeter bolts hold the two Puller Plates together, slide the Horseshoe Plate of the Flange Puller behind the (Shaft) side of the Inner Flange.

3.Tighten the center puller bolt to remove the Inner Flange from the Blade Shaft.

PAGE 48 — STOW CS4030 SAW • OPERATION MANUAL — REV. #0 (12/13/07)