![](/images/new-backgrounds/1209130/20913035x1.webp)
STUDER INNOTEC | |
|
|
5.3Battery Condition
The voltage levels and charge characteristics can be changed through Programming. The instruc- tion for programming of battery levels is in the section „Programming”
5.4Fault indicator
5.4.1Overtemp. (10)
For the time being the
5.4.2Overload (11)
The LED indicator lights when the inverter is suffering a load higher than the permitted overload during more than 5 seconds.
5.4.3Battery low/high
The LED indicator lights when the battery voltage is too low and blinks when it is too high.
5.5Remote alarm contact and on/off control
In the Remote Control there is an additional Alarm Contact and a Control Input built in. These two functions are available through Tip-
jack RJ11/4 for use. This Auxiliary Contact is Front / Work Contact (max. 0.5A!), which is independent of
the Auxiliary Contact of the XP- COMPACT. This contact is active in case of an alarm of the XP-
COMPACT.
The Control Input is connected in parallel to the ON/OFF- push button. The
1 2 3 4
COMPACT
Remote control
Dry contact only
Order Number for Remote Control:
Dimensions: H x B x T / 111.5 x 136.5 x 25mm
Caution: No external voltage should be connected to this Input Control.
5.6Manual control of the auxiliary contact
The auxiliary Contact can be operated at any time with the Push Button 21 (AUX. CONTACT). The LED 6 „Contact manual“ lights up as information that the Contact is manually operated, and LED 5 „Contact active“ lights up when the Contact is active. By pushing the Push Button 21 a second time, the Contact is deactivated. By pushing it the third time, automatic functions are restored.
When the auxiliary contact is manually controlled (LED 6 lit) the programmed control of the contact is disabled. In program mode, the auxiliary contact may be automatically actuated by every dis- played status of the
6 Programming
Programming the charging parameter and the auxiliary contact is only possible thru the optional remote control. This programming allows to change the factory setting parameters for battery man- agement and auxiliary contact.
User manual |
| 17 |