Sub-Zero BI-36U, BI-36R Dispenser Specifications, Flush option, Proud option, Handle placement

Dispenser Specifications 28

Dispenser Area. For Models BI-42SD and BI-48SD, the refrigerator door panel must include a cut-out to accommodate the dispenser glasswell and bezel. The thickness of the panel in this area can range from 1/4" (6) to a maximum of 11/8" (29).

IMPORTANT NOTE: Regardless of the thickness of the panel for Model BI-42SD or BI-48SD, you must plan for a flat landing area for the decorative bezel surrounding the glasswell area. The illustration to the right provides exact bezel dimensions. Refer to the appropriate panel specifi- cations page for exact cut-out location. This landing area can be accomplished in a number of different ways. These photos show two options.

One option (flush) is to rout the panel so the bezel will be flush with rails and stiles. You must rout a space to accommodate the height and width of the bezel. The width of the stile immediately adjacent to the bezel must be 17/16" (37). Do not cut the entire stile to this dimen- sion.

The other option (proud) shows a boxed out landing area for the bezel using stiles and rails to create this space. In this application, the bezel will sit proud of the stiles and rails. The total thickness of the panels at this level must not exceed 11/8" (29).

For overlay and flush inset Models BI-42SD and BI-48SD, mounting placement of the refrigerator door handle must assure proper access to the glasswell and adequate clearance under the handle. The handle placement illus- tration shows the relation of the refrigerator door handle to the glasswell bezel on stainless steel models.

Flush option. Proud option.

5/8"		3/32"
(16)		(2)
6	5/16" (160)	1"
		(25)
		1/8" (3)	Glasswell
			Profile
		radius
		2"	Handle
			Profile
		(51)
12 7/8"		Handle placement.
(327)

Dispenser dimensions.