Sub-Zero BI-36F, BI-48SD, BI-42S, BI-36UG, BI-36RG, BI-36S manual Dual Installations

Dual Installations 30

Dual Standard Installations. Two framed, overlay or stainless steel units may be placed side by side in a dual installation. Some dual standard installations will require a dual installation kit, available through your Sub-Zero dealer. If you are installing two units side by side in a flush inset application refer to page 33.

A custom filler strip can be used in between two units in a framed, overlay or stainless steel design application. It is recommended that the filler strip be at least 2" (51) wide, to prevent condensation between the units. Be sure to add the filler strip width to your rough opening width. Refer to the full-scale template on page 41.

Dual installations without a filler strip can only be accom- plished using two units with opposite hinges as shown in illustration A below. The dual installations shown in illus- trations B and C require a filler strip.

IMPORTANT NOTE: For the application shown in illustra- tion A, a dual installation accessory kit is required. Refer

Dual Standard Installationto page 36 for information on dual installation accessory kits.

Dual Installations

Dual Installation Panel Requirements

MAX WEIGHT PER PANEL
BI-36R, BI-36RG and BI-36F	75 lbs (34 kg)
All Other Models	50 lbs (23 kg)
Dual Wide Grille Panel	26 lbs (12 kg)
MIN PANEL THICKNESS
Framed Panels	1/4" (6)
Overlay and Flush Inset Panels	5/8" (16)

WITHOUT FILLER STRIP

FILLER STRIP REQUIRED

FILLER STRIP REQUIRED

Illus. A Illus. B Illus. C