Undercounter Installation | 10 |
|
|
Overlay Panel Installation
MODELS
Inspect the overlay door panel for minimum thickness and weight limit. Remove the two panel mounting brackets attached to the front of the door and set aside.
Place the overlay panel lying face down on a protected surface to ensure that the front is not scratched or damaged. Position the plastic template (provided) flush with the lower edge of the door panel. Be sure you are following the exact location for the
Once you have located the proper placement for the brackets, mark the pilot holes, remove the template and drill pilot holes for mounting the brackets. It is best to start with a few holes, position the bracket, drill the remaining pilot holes and then secure the mounting bracket with the #8 x 1/2" screws provided.
Exercise caution when drilling holes for mounting hardware. This is especially critical with inset panels.
Before attaching the overlay panel to the door, insert two screws, one in the center of each mounting position, just far enough that the slotted holes on the hinge side door panel bracket will slide under the heads. These positioning screws will support the door panel during installation and adjustment. Refer to the illustration below.
Install the door panel by engaging the tabbed bracket to the handle side of the door first and then sliding the hinge side mounting bracket onto the positioning screws on the hinge side of the door. The panel can be adjusted 1/4" (6) up and down and side to side.
Once the door panel is in place and adjusted correctly, attach the four remaining #10 x 1/2" screws to the hinge side mounting bracket and install the magnetic decorative caps as shown in the illustration below.
DOOR |
PANEL |
BRACKET |
SCREW |
215/8" (549) 
7/8" (22)
RH DOOR SWING
151/16"
(382)
35/8" | 31/2" |
(92)(89)
301/16"
(764)
LH DOOR SWING
CAP |
Panel installation.
233/4" (603)
Overlay panel bracket location.
