10-3-3 STATOR
Holding the rear bracket and stator, fit them to
thefrontbracket.Matchthe mounting hole of
the rearbracketandthat of therotor bearing, and softly strike the outsideperiphery of the rear bracket with a plastic hammer.
(See Fig.
Attach the stator cover around the stator.
Fig.
Tighten the three M6 boll i to fix the rearbrack- et to the front bracket.
TIGHTENINGTORQUE 4.0 - 5.4ft Ibs. 535 - 735 N cm 55 -
(4)Put the grommet in the grooveof the rear bracket and secure the wire.
Note :Fix the wire from the stator and diode stack with theclamp at the bottom of the groove.
Put condenser to rear cover.
5 0 X 10mm tapping Screw
TIGHTENINGTORQUE 2.4 - 4.0 ft - Ibs. 325 - 535 N cm
55 kg cm
Condenser
Fjg.
