10-3-5 ENDCOVER
"Set theend cover on the rear bracket with four M5 X 10 screws.
Mountthe bracket (cover) on the rear bracket and secure them with M8 X30 bolts.
Fig.
(1)Connect the rubber pipe to the engine carburetor and fasten it with a hose clamp.
Attach the banjo to the opposite end of the rubber pipe, tighten it with a hose clamp, and fasten the pipe to the fuel strainerwith the banjobolt.
Note :Mount the fuel strainer with the banjo outlet upward.
_ -
(2)Fasten the strainerto the front bracket with the joint nuts.
(3)Secure the mounting tabon the bottom of the fuel tank and the blower housing with M6 X12 bolts. Insert the attaching bolts on the other end of tank into the mount bracket hole andsecure it with two M8 nuts.
(4)Connect the rubber pipe
First, fit the hose clampon the rubber pipe, connect the strainer and fuel tank, then fasten the rubber pipe with the hose clamps.
Note :Apply a drop of oil to the rubber pipe so that it may easily be connected to the strainer and the fuel tank.
(1)Match the handle hole with the bolt on the top of the fuel tankand secure it with M8 nuts.
(2)Completely insert the breather pipe over the bolt.
Note :There is a hole at the center of the breather pipefor air bleeding.Set the breather pipeso that the hole is directed upward.
(3)Fix both ends of the handle cover with M3 X 10 screws.
- 44 -
