Summit HL-630 OPC manual Okidata C3000 Series, Okidata C5100 Series, Okidata OL-400/800 OPC

Okidata C3000 Series

Okidata OPC Color Cartridge Part # 42126661,

42126660, 42126659, 42126658

OEM Stated Yield: 15,000 All

These machines have a glass fuse that is used to reset the machine. The fuse is located in the gear end cap of the cartridge. We have not confirmed this yet, but we believe that the fuse is the same as the SF-5100. The fuse must be replaced each cycle.

Okidata C5100 Series

Okidata OPC Color Cartridge Part # 42126604,

42126603, 42126602, 42126601

OEM Stated Yield: 15,000 All

These machines have a glass fuse that is used to reset the machine. The fuse is located in the gear end cap of the cartridge. We have not confirmed this yet, but we believe that the fuse is the same as the SF-5100. The fuse must be replaced each cycle

Okidata OL-400/800 OPC

Okidata OPC cartridge part # 56106601

OEM Stated Yield: 15,000

Although all of these machines use the same cartridge, the reset procedures are different.

Reset procedure for the Okidata OL-800 Series

Printers

Turn off the printer

While holding the MENU1/MENU2 button down, turn the printer back on. Keep holding the button down until you see "MAINTENANCE MODE" on the display panel. Release the button.

Press the MENU1/MENU2 button three times. The display will read "DRUM COUNT RESET". Press the ENTER/QUIET button. The display will read "DRUM COUNT RESET RESETTING", then "INITIALIZING", then "WARMING UP", and finally "ON LINE". The counter is reset!

Reset procedure for all other OL series Laser

Printers.

Turn the printer off.

Press and hold the RESET button (not the Menu Reset), and turn the printer on. Hold the button down until you see "DRUM RESET" on the display. Release the button.

Run a self-test. Turn the printer off-line and press the PRINT

FONT/SELF TEST button once and release. The printer will print out a page with the installed fonts, and the page count of the printer.

Reset procedure for the "DOC-IT" Document

Processing Systems.

Turn the DOC-IT on, and re-initialize it: either re- boot the computer, or type DOCIT at the DOS prompt and press enter.

Press and hold the ENTER key for 3 seconds, when you release it you should see "Administration" on the display.

Press the down arrow key until you see: Reset drum ctr.? YES/NO

Press the left arrow key to move the check mark next to "YES". Then

Press ENTER.

Press any key to leave the Administration menu. The counter is reset!

25