cartridge is changed. A new fuse is not needed. However if the machine says change cartridge, the fuse is needed. Since you really have no way to know the state of your customer’s machine, we recommend that the fuse be replaced each cycle. These fuses are very inexpensive, and this way you have no worries! Starter cartridges can come with plastic dummy fuses. Those fuses must be replaced with a real fuse. The fuse is a 125V, 100mA, 5x20mm fast acting glass type.

This cartridge uses an optical reset similar to the Panasonic 4410. The waste chamber must be spotless, and the float in the down position. There is a clear plastic bubble on top of the cartridge. This is what the sensor looks at and it must be spotless! The J7 code is triggered when the waste chamber fills up and moves the float into the bubble, interrupting the optical sensor.

Xerox XC-23/33 OPC

13R546

OEM Stated Yield: 30,000

To reset the counter in the XC-23 OPC cartridges the connector on the rear of the cartridge must be replaced. This will clear the J7 or J8 codes. J7= change copy cartridge, J8 = wrong or bad connector. New replacement connectors are not currently available, but there are companies that can repair the OEM connector for you.

Xerox 4525

113R00195 (Lexmark W820)

OEM Stated Yield: 30,000

To reset the counter in the 4525 and Lexmark W820 cartridges the connector on the rear of the cartridge must be replaced. This will clear the J1 or J7 codes. J1= Toner Out, J7 = Change cartridge. The connector and cartridges look similar to the N24 style, but they are different, and NOT interchangeable.

Xerox 1012 OPC

13R8, 113R92

OEM Stated Yield: 18,000

The 1012 OPC cartridges look very similar to the 5011 and 5012, but they are different and NOT interchangeable.

There are now many different Xerox part numbers for these cartridges. They are interchangeable, just sold from different sources. A list of some of them is as follows: 13R8 (US), 13R10, 13R30, 113R92 (Retail Stores), and 13R500.

Xerox 5011 OPC

Xerox cartridge Part # 13R44

OEM Stated Yield: 18,000

The 5011 OPC cartridges look very similar to the1012 and 5012, but they are different and NOT interchangeable.

These cartridges use a reset fuse board located inside the connector. The connector must be un-soldered and a new one soldered in. Be very careful not to melt the cable when soldering. Make sure that you

43

Page 43
Image 43
Summit HL-630 OPC manual Xerox XC-23/33 OPC, Xerox 1012 OPC, Xerox 5011 OPC