Sun Microsystems 2.0 manual Green OK LED goes to Standby

■Green OK LED goes to Standby.

2.Activate the NEM by pressing the Attention button, and the green OK LED goes to Slow blink.

■When all links to active blades have been made, the green OK LED goes to Solid On.

■Ready to Remove status shows Not Ready in the ILOM interfaces.

TABLE 2-3NEM LED Status

Ready-to-Remove	Service Action	OK LED (Power, Attention,	Status
LED	Required LED	and Connected)
Color: Blue	Color: Yellow	Color: Green
Location: Top	Location: Middle	Location: Bottom
On	Off	Off	Ready to remove
Off	On	Off	Service attention required
Off	Off	Very slow blink	Standby
Off	Off	Slow blink	Connecting links to blades
Off	Off	On	Links connected to blades

Ready-to-Remove

LED

Service Action Required	Attention button
LED
OK LED (Power,	Locator LED
Attention, and Connected)	Locator button

FIGURE 2-5LEDs, Attention and Locator Buttons

The Attention button enables you to activate (if inserting) or prepare to remove (if removing) a NEM during a hot-plug operation.

Chapter 2 Hardware Installation and Removal 17