Sun Microsystems 6U manual Remove the wrist strap from the chassis and from your wrist

10.Locate the hot-swap LED on the front card to determine if the card has been activated and is attached to the system (see FIGURE 2-11).

Hot-swap LED

Compact PCI

Hot

Swap

FIGURE 2-11Location of the Rear-Access Adapter’s Hot-Swap LED on the Front Card

The hot-swapLED shows whether the adapter has been activated.

■If the hot-swap LED is OFF (unlit), the I/O slots in the server have been set to full hot swap and the adapter has been activated. Go to Step 15.

■If the hot-swap LED is ON, then the I/O slots in the server have been set to basic hot swap. You must use software commands to activate the I/O card. Go to Step 11.

Note –You should also use the hot-swap LEDs on the server when installing the adapter. For example, Netra ct servers contain an OK to Remove LED ( ) on the system status panel that is used like the hot-swap LED on this adapter. Refer to your system’s service manual for a description on how the hot-swap LEDs are used during a hot-swap installation.

11. Remove the wrist strap from the chassis and from your wrist.

Chapter 2 Installing the Rear-Access Adapter 19