Sun Microsystems 6U manual To Power On the Server

8.Push the adapter all the way into the slot until the two ejection levers move inward.

The tabs of the ejection levers (see FIGURE 3-4) should fit smoothly in the rectangular cutouts in the top and bottom of the slot.

9.Close the ejection levers by pushing the levers in toward the adapter.

The adapter may contain different types of ejection levers. For example, FIGURE 3-5 shows two possible types of levers. The levers may also contain a locking mechanism that will lock when the levers have been properly closed. When installed correctly, the ejection lever tabs will fit smoothly into the rectangular cutouts in the top and bottom of the slot (FIGURE 3-6).

10.Using a No. 0 Phillips screwdriver, tighten the captive screws inside the adapter’s top and bottom ejection levers.

The adapter may contain different types of ejection levers. For example, FIGURE 3-8shows two possible types of levers.

11.Remove the wrist strap from the chassis and your wrist.

See “Connecting the Cables to the Front-Access Adapter” on page 40 for instructions on connecting the cables to the adapter.

▼To Power On the Server

This procedure describes a general overview of powering on the server. Refer to your server’s documentation for the exact procedure.

1.Before powering on the server, make sure that any peripheral devices connected to the server are powered on.

2.Follow the appropriate procedures, as documented in the server’s hardware installation manual, to power on the system.

Refer to the server’s documentation for the complete power on procedure.

For example, if you installed the adapter in a Netra ct server, refer to the Netra ct Server Service Manual. This manual contains the powering on procedures.

38 Sun Quad FastEthernet 6U CompactPCI Adapter Installation and User’s Guide • June 2000