Sun Microsystems 805-1797-10 manual Using the ndd Utility in Interactive Mode

Using the ndd Utility in Interactive Mode

1.To modify a parameter value in interactive mode, specify ndd /dev/qfe, as shown below.

The ndd utility then prompts you for the name of the parameter:

#ndd /dev/qfe

name to get/set? (Enter the parameter name or ? to view all parameters)

After entering the parameter name, the ndd utility prompts you for the parameter value (see Table C–1 through Table C–8).

1.To list all the parameters supported by the qfe driver, type ndd /dev/qfe \?. (See Table C–1 through Table C–8 for parameter descriptions.)

CODE EXAMPLE C–1Example of Listing All Parameters Supported by the qfe Driver

# ndd /dev/qfe \?
?	(read only)
transceiver_inuse	(read only)
link_status	(read only)
link_speed	(read only)
link_mode	(read only)
ipg1	(read and write)
ipg2	(read and write)
use_int_xcvr	(read and write)
pace_size	(read and write)
adv_autoneg_cap	(read and write)
adv_100fdx_cap	(read and write)
adv_100hdx_cap	(read and write)
adv_10fdx_cap	(read and write)
adv_10hdx_cap	(read and write)
autoneg_cap	(read only)
100fdx_cap	(read only)
100hdx_cap	(read only)
10fdx_cap	(read only)
10hdx_cap	(read only)
lp_autoneg_cap	(read only)
lp_100fdx_cap	(read only)
lp_100hdx_cap	(read only)
lp_10fdx_cap	(read only)
lp_10hdx_cap	(read only)
instance	(read and write)
lance_mode	(read and write)
ipg0	(read and write)
#

Configuring the Quad FastEthernet Device Driver Parameters 35