3.1StorEdge D1000 Disk Array Settings
This section describes how to set attributes for the StorEdge D1000 disk arrays (FIGURE 3-1) in the following configurations:
■1x2—One controller module with two StorEdge D1000 disk arrays
■1x5—One controller module with five StorEdge D1000 disk arrays
■2x7—Two controller modules with seven StorEdge D1000 disk arrays
■3x15—Three controller modules with fifteen StorEdge D1000 disk arrays
For the D1000 disk arrays, you must set the following attributes:
■Option switch
■Module ID
■SCSI jumper cables and terminators
Option switch
Module ID
IN/OUT-1 | IN/OUT-1 | IN/OUT -2 | IN/OUT -2 |
Rear
FIGURE 3-1StorEdge D1000 Disk Array
3-2Sun StorEdge A3500/A3500FC Hardware Configuration Guide • December 1999
