Sun Microsystems A3500FC manual Ultra 2 Host System Power Connection Requirement

1.3Ultra 2 Host System Power Connection Requirement

You can connect a controller module to an Ultra 2 host system; however, you must connect the power cord of the Ultra 2 host to one of the AC power sequencers in the expansion cabinet that contains the controller module.

Note –The RAID Manager 6.22 software does not support Ultra 2 host systems.

You need to order one of the following power cords depending on the type of power sequencer in the expansion cabinet (FIGURE 1-5):

■Ultra Enterprise™ expansion cabinet and StorEdge expansion cabinet— part number 530-2197

■1422 mm/56-inch Data Center expansion cabinet—part number 180-1189 (United States) or 180-1190 NEMA (European)

Caution –Failure to connect the power cord correctly as described here may cause excessive ground current that could damage the system.

Chapter 1 SCSI Host Connections 1-7