2.3Installing the Hub

2.3.1Tools You Will Need

You will need a #2 Phillips screwdriver.

2.3.2Preparing the Cabinet

Follow the instruction in your system or expansion cabinet documentation. If necessary, be sure to:

Extend the antitilt bar

Remove or open the top front panel

Remove or open the rear panel

2.3.3Installing the Mounting Tray in the Cabinet

1.Select the correct mounting holes in the cabinet to use for the tray.

Refer to the online Rackmount Placement Matrix for mounting hole information.

2-2Sun StorEdge FC-100 Hub Installation and Service Manual • September 1998

Page 24
Image 24
Sun Microsystems FC-100 service manual Installing the Hub, Tools You Will Need, Preparing the Cabinet