Sun Quad FastEthernet PCI Adapter Installation User’s Guide
Please Recycle
Regulatory Compliance Statements
DOC Class a Notice Avis DOC, Classe a
EMC
Page
Contents
Specifications
Running Diagnostics Tests
Page
Preface
How This Book Is Organized
Unix Commands
Related Documents
Typographic Conventions
Shell Prompts
Sun Welcomes Your Comments
Ordering Sun Documents
Table P-1SunExpress Contact Information
Product Overview
1Sun Quad FastEthernet PCI adapter
Features
2Sun Quad FastEthernet PCI adapter Back Panel
Checking the OpenBoot Prom Revision Level
Displaying the OpenBoot Prom Revision Level
Hardware and Software Requirements
1Hardware and Software Requirements
Page
Installing the Adapter
Using a text editor, add the following line to the end
Installing the Adapter
Verifying the Installation
Ok show-devs
Examining Network Activity
Rebooting the System
Perform a reconfiguration boot on the system
Page
Installing the Driver Software
Configuring the Driver Software
Configuring the Host Files
Etc/hosts file
Reboot your system
# cat /etc/hosts
Booting From the Network
At the ok prompt type
Post-Installation Procedures Optional
Configuring Driver Parameters
Increasing TCP/IP Performance
As superuser root, type
Forcing Network Speed Between 10 Mbps and 100 Mbps
Type
Auto-Negotiation
Local-mac-address Property
Physical Dimensions
Specifications
Table A-1Physical Dimensions
Power Requirements
Performance Specifications
Table A-2Power Requirements
Table A-3Performance Specifications
Interface Signals
Ethernet channels
Page
Configuring the Quad FastEthernet Device Driver Parameters
Internal Transceiver
Driver Parameter Values and Definitions
Qfe Driver Parameter, Status, and Descriptions
Defining the Current Status
Inter-Packet Gap Parameters
Table B-1qfe Driver Parameter, Status, and Descriptions
Table B-2Read-Only Parameters Defining the Current Status
Ipg1 = 8 default at initialization
Table B-5Operational Mode Parameters
Operational Mode Parameters
Table B-4Parameters Defining lancemode and ipg0
Defining the Number of Back-to-Back Packets to Transmit
Reporting Transceiver Capabilities
Table B-6Back-to-back Packet Transmission Capability
Table B-7Read-Only Transceiver Capabilities
Reporting the Link Partner Capabilities
Table B-8Read-Only Link Partner Capabilities
Setting qfe Driver Parameters
Setting Parameters Using the ndd Utility
To Specify the Device Instance for the ndd Utility
Use the instance number to select the device
Using the ndd Utility in Non-Interactive Mode
To modify a parameter value, use the -setoption
# ndd /dev/qfe \?
Setting Forced Mode
Setting Parameters in the /etc/system File
Table B-9Setting Variables in the /etc/system File
Setting Parameters Using the qfe.conf File
Setting the ipg1 and ipg2 Parameters
Setting ipg Driver Parameters Using a qfe.conf File
Etc/pathtoinst file
Set the ipg1 and ipg2 parameters for the above four devices
Kernel/drv/qfe.conf file
Running Diagnostics Tests
Using the OpenBoot Prom FCode Selftest
Running the Ethernet FCode Selftest Diagnostic
Reset the system
Shut down the system
Type show-devsto display the list of devices
Ok setenv diag-switch? false
Set the auto-boot?configuration parameter to true
Reset and reboot the system
Index
Editing
Editing, 11 example
Creating, 12 editing, 11 examples
LEDs
Watch-net-all output
Page
Ordering Sun Documents
AIR Mail PAR Avion