Sunbeam JE9000 manual Operating your Slow Juicer

Models: JE9000

1 24
Download 24 pages 56.12 Kb
Page 11
Image 11

Operating your Slow Juicer

Note: Slow juicer should be completely assembled before use using directions on page 7.

1.Ensure the control switch on the juicer is in the ‘Off’ position and insert the power cord into a 230-240V AC power outlet and turn the power ‘On’.

2.Clean and chop fruit and vegetables ready for juicing.

Note: The feed chute allows some whole fruit and vegetables to be juiced however some fruit and vegetables may require other preparation before juicing, such as peeling and removing stones.

3.Ensure that the juicer has been assembled correctly and all parts are firmly in place.

The juicer will not operate if it has not been correctly assembled.

4.Place the juice container under the juice spout and pulp container under the waste pulp spout.

5.Select ‘On’ with the control switch by pushing the top of the switch.

Important: Do not operate for more than 3½ minutes at a time when juicing heavy loads

or continuously for more than 15 minutes.

Important: Do not use the slow juicer for extended periods without inserting ingredients as this can damage the juicer.

6.With the juicer in operation, place the fruit and vegetables into the feed chute. Using the pusher, slowly guide the fruit and vegetables down the feed chute and onto the juicing screw.

Tip: For maximum juice extraction, allow the juicing screw to pull the food down into the juicer and gently use the food pusher when required.

Important: If the juicing screw becomes jammed and the juicer stop operating, press the control switch to the ‘Off’ position. After the juicer has come to a complete stop, select ‘Reverse’ at the bottom of the control switch until the food becomes dislodged. Then press control switch back to the ‘On’ position.

7.Filtered juice from the fruit and vegetables will flow from the juice spout and waste pulp will be collected from the pulp spout.

8.Immediately after use, slowly pour a glass of water down the feed chute to help clean your juicer. Ensure that the pulp and juice containers are positioned to collect the waste water. This process can also be used in between juices to flush the slow juicer.

9.When juicing is complete ensure that the slow juicer is switched ‘Off’ and unplugged from the power outlet.

9

Page 11
Image 11
Sunbeam JE9000 manual Operating your Slow Juicer