Sunbeam LC6250 Fitting/using the tools on your MultiProcessor, Placing the spindle, Pictured

Fitting/using the tools on your MultiProcessor

Note: All attachments must be firmly attached to the spindle. Always adjust the attachments until you are sure that they are correctly fitted.

Placing the spindle

1.Fit the spindle onto the drive shaft, see Figure 6.

LC6250 spindle

Pictured

drive shaft

Fig 6

Processing Blade

1.Fit the processor bowl and spindle as detailed previously in Figures 2, 3 & 6.

2.Remove the protective cover from the stainless steel processing blade, see Figure 7.

Fig 7

3.Fit the processing blade over the spindle and press firmly into place, see Figure 8.

chopping
blade	spindle

	LC6250
Fig 8	Pictured

Warning: Use extreme caution as blades are sharp. Always handle the chopping blade by its central plastic section.

4.Place food into the processing bowl.

5.Fit the processing bowl cover to the processing bowl, see Figures 4 & 5 and place the food pusher in the feed tube.

6.Plug the power cord into a 230-240V AC power outlet and turn the power ‘ON’.

7.Select the required speed.

8.When processing is complete, remove the spindle and blade from the processing bowl before removing the processed food.

Note: After cleaning, always replace the protective cover on the stainless steel processing blade.

Dough Blade

1.Fit the processor bowl and spindle as detailed previously, in Figures 2, 3 & 6.

2.Fit the dough blade over the spindle and press firmly into place, see Figure 9.

dough
blade	spindle
Fig 9	LC6250
	Pictured

3.Place ingredients into the processing bowl.

4.Fit the processing bowl cover to the processing bowl, see Figures 4 & 5 and place the food pusher in the feed tube.

5.Plug the power cord into a 230-240V AC power outlet and turn the power ‘ON’.

6.Select required speed.

7.When processing is complete, remove the spindle and blade from the processing bowl before removing the dough.

12