TV Installation - Detachable Speaker Module Installation
Detachable Speaker Module Installation
Tools Needed: Phillips screwdriver
Note:
a. If you mount the TV on the Table Stand, the Detachable Speaker Module must be installed before you attach the Table Stand.
b. If you mount the TV to a ceiling or wall mount, it is best to install the Detachable Speaker Module after the TV has been mounted.
1.Prepare a flat work surface, free of any debris or items which may scratch the front surface of the TV.
2.Lay the TV
WARNING: Use at least two people when transporting the TV.
3.Position the TV so that the bottom edge overhangs the table by about one inch.
4.On the bottom rim of the TV, there are four Pan Head Mounting Screws. Remove the Pan Head Mounting Screws, and set aside.
Important Note: Always replace mounting screws. Failure to do so will allow water to seep inside your TV. This can cause serious injury and can damage your TV.
5.Turn the Speaker Module with the speaker grill facing the floor, and align the Speaker Mounting Holes to the TV Mounting Holes. Replace Pan Head Mounting Screws through Speaker Mounting Holes and TV Mounting Holes. (Figure 2).
6.Screw securely (Figure 3).
7.Unscrew the three Thumb Screws, and pull the Connect Source Cover open (Figure 4).
8.Take the Speaker Cable from the speaker, making sure that the Speaker Cable Wire is placed over the right side of the Rubber Sealing Gasket (Figure 5), and plug it into the Speaker Connector.
10.When you close the Connect Source Cover, be sure that the Speaker Cable Wire is placed across the outside portion of the Rubber Sealing Gasket. The Speaker Cable Wire should not be placed across the bottom of the Rubber Sealing Gasket (Figure 6).
Pan Head Screws
TV and Speaker Module
Mounting Holes
Figure 4 | Thumb Screws | Figure 5 | Speaker Connector | Figure 6 |
|
|
|
|
Connect Source Cover |
|
Rubber Sealing |
|
Gasket | Speaker Cable |
|
Speaker Cable Wire should not come out of this area
SunBriteTV Model | Page 7 |
