CHAPTER 3

Remote Control

The TGR-401 remote control is

many remotes in one. There are ten device buttons, ve on either side of the display, and each allows the remote to operate one piece of equip- ment.

From the factory, the device buttons on page 1 are labeled: HD/BD, SAT, DVR, MP3, DVD, CABLE, VCR, CD, ZONE2, and TG401.

Only the TG401, ZONE2 and MP3 buttons are pre-programmed, and these allow the remote to operate your TGR-401, Zone 2 and the optional VIA!migo iPod dock. The remote can

Light

The button on the right side of the remote brie y turns on the lights for the buttons and display. Pressing it again will turn it off. The number of seconds can be varied, or it can be disabled.

ON

IR WINDOW

LCD

OFF

LIGHT

Device Buttons

DEVICE

Once you press a device button,

Buttons

all the device buttons change label

 

and function to become buttons to op-

 

erate your device. There are multiple

PAGE

pages per device, and you can move

PAGE

between them using the PAGE button.

MAIN

 

MAIN

DEVICE Buttons

FAV

FAV

be set to operate your other remote controlled equipment. This is done in three ways from the hidden SETUP menu:

1.Entering a code from the tables at the end of this manual

2.Stepping through the codes

3.Learning from your other remotes

See Remote Setup on page 27 for more details.

LCD Display

The top line shows the present device, mode or status, and it shows when a remote command is being transmitted. The bottom line shows the page number, status and basic instructions during programming.

The main part of the display shows the labels of the ten device buttons. You can change any label and cus- tomize the remote to t your system. Note: this is not a touch-sensitive screen, just a way of labeling the device buttons on each side, and showing instructions and status.

Contrast

The contrast of the display can be changed by holding down the MAIN button and pressing the navigation pad UP or DOWN.

PAGE

VOL

Use this to jump to various display

 

pages. For example, if you press the

MENU

TG401 device button, the display

 

changes to show buttons that control

 

your TGR-401. If you press PAGE, the

 

display will move to page 2, showing

 

more functions for the TGR-401.

 

MAIN

1

PREV

MUTE

CH

CH

GUIDE

INFO

EXIT

SEL

Navigation

2 3

This button will return the remote

display back to the Main menu.

4

5

6

 

 

 

Depending on which mode you are

7

8

9

in, it may take two or more presses.

+10

0

 

This will help you get back to the Main

ENT

 

 

 

menu if you get lost in the menus.

FAV

This button allows you to step through ve display pages of your favorite TV and radio stations. These can be set and re-labeled to suit.

Navigation Pad

This pad and surrounding buttons are used to operate standard DVD menus, and VCR and Tape transport controls. In TGR-401 mode, if you press MENU, the On Screen Display will appear and the navigation buttons can be used to select and adjust the various items.

Batteries

The remote takes four AAA bat- teries inside the rear compartment. These should last about six months in normal use, before a low-battery warning appears.

25

User's Manual

Page 25
Image 25
Sunfire TGR-401-230, TGR401 manual Remote Control, Main, Fav