Sunrise Medical owner manual Articulating or Elevating Legrest GTX SWING-AWAY 12, Backrest

E N G L I S H

G.SWING-IN/SWING-OUT HANGERS AND FOOTRESTS (GTX SWING-AWAY) (60º, 70º, 70ºV, 70° HEMI, 80° OR 90º)

1.Installation 10

a.Place swing-in/swing-out pivot saddle into the receiver on front frame tube with the footrest facing outward from the frame. ( 10 -M)

b.Rotate the footrest inward until it locks into place on locking bolt. ( 10 -N)

2.Removal

a.To remove footrest, push release latch toward the frame.

b.Rotate footrest outward and lift.

3.Height Adjustment 11

a.Loosen set screws (O).

b.Slide footrest extension up or down inside frame tube to desired height.

c.Tighten set screws.

H. ARTICULATING OR ELEVATING LEGREST (GTX SWING-AWAY) 12 13

1. Installation

To install or remove articulating legrest (ALR) or elevating legrest (ELR) see instructions for swing- away hangers and footrests.

2.Adjustment

a.To raise legrest, lift to desired position. Legrest will automatically lock in place.

b.To lower, while seated in chair, press release lever (A) forward and lower legrest to desired position. Legrest will automatically lock in place.

I. FOOTREST HEIGHT ADJUSTMENT (GTX FIXED FRONT) 14 15

To adjust the height of your footrest, remove the screw (B) on both sides of the footrest. Slide the footrest up or down to the new desired height and tighten the two screws back into place. Use a torque setting of 120 in-lbs (13.6 Nm). It is recommended that you maintain a minimum of 2.0 inches (5 cm) between the lowest point on the footrest and the floor. Additionally, both sides of the footplate should be of equal height.This will provide adequate clearance for uneven surfaces and prevent damage to your footrest.

To adjust angle of footrest, loosen screw (C) 15 . Change angle of footplate to desired position. Tighten screw (C) on both sides of footrest. Use a torque setting of 120 in-lbs (13.6 Nm).

NOTE– Footrest must be in locked position before riding in wheelchair.

J. BACKREST 16

1.Height Adjustment

a.Remove the backrest upholstery from the frame.

b.You will see the backrest tube which telescopes into the frame and is secured by a screw on the side of the frame.

c.There are holes 1 inch apart that you may choose from to set the back height.

d.Remove the two backrest bolts from the rear frame tubes.

e.After selecting the proper height, insert bolt through frame and backrest tube.

f.Slide the backrest upholstery back over both backrest tubes.

	11
	O
A	12
Articulating
Legrest
	13
	A
Elevating
Legrest
	14
B
B
	15
C
C
	16

15 052124 Rev. D