SUPER MICRO Computer Super PIIIDM4 Auto-Detect Hard Disks, EPP Version, Parallel Port IRQ, Bios

Chapter 4: BIOS

data transfer driven by the host device. Use ECP (Extended Capabilities Port) to achieve data transfer rates of up to 2.5 Mbps. ECP uses the DMA protocol and provides symmetric bidirectional communication. Note: The Optimal default setting for this option is ECP and the Fail-Safe setting is Normal.

EPP Version

The settings are Enabled and Disabled. Note: The Optimal and Fail-Safe default settings are N/A.

Parallel Port IRQ

This option specifies the IRQ to be used by the parallel port. The settings are 5 and 7.

Parallel Port ECP DMA Channel

This option is only available if the setting of the parallel port mode option is ECP. The settings are 0, 1, 2, 3, 5, 6 and 7.

Onboard MIDI Port

This option specifies the base address to be used for the MIDI port. The settings are Disabled, 300h and 330h.

MIDI IRQ

This option specifies the IRQ to be used for the parallel port. The settings are 5, 7, 9 and 10.

Onboard Game Port

This option is used to either Enable or Disable the Game Port.

Auto-Detect Hard Disks

This section allows BIOS to look for and configure any hard disk drives on your system. After highlighting this option, hit <Enter> and wait momentarily while BIOS performs the auto-detect. You will soon see the disk drives appear properly configured.

Change User Password

Change Supervisor Password

BIOS

4-19