SVAT Electronics CLEARVU4 instruction manual Power to DVR

SVAT ELECTRONICS

now you can see

4. POWER TO DVR

1.Insert the power supply wire into the rear DC 12V Port on the DVR.

2.Insert the power cord into the power supply.

3.Plug the power cord into a power outlet. We recommend using a surge protected power bar and/or Uninterrupted Power Supply (UPS) backup. To turn the DVR on and off, use the power switch on your UPS or power bar. This DVR does not have a power switch. This is for your security and helps to prevent users from accidentally turning the DVR off.

The DVR will power on and you will see a boot screen. After the DVR initializes your cameras should be displayed and recording will begin immediately.

Important notes before operation

1.To power off the DVR, make sure the DVR is not recording to prevent file corruption. If on manual record, press STOP to stop recording and wait for the REC light to turn off before you power off the DVR. If in schedule record, press MENU and enter the password to enter the menu screen. When the record light turns off, you can power off the DVR.

2.The default password is 12345678.

3.This DVR does not support HDD hot swap. To prevent damage, please enter the main menu to stop all HDD activities, then power-off the device before replacing the hard disk.

4.After power-on, the DVR auto detects the video system (NTSC/PAL) of the first camera connected. When no camera has been connected, the video system will be the same as the previous setup.

5.After power-on the system auto enters 9-split screen mode, and continues with the previously setup recording schedule (auto resume recording)

CLEARVU4 4