SVAT ELECTRONICS
PI1000 SETUP
now you can see
1.The power switch is situated on the top of the device.
NOTE: Each time the PI1000 is powered on, the system
2.After power on, the system auto enters live monitoring. If the system was previously set to scheduled or motion activated recording, it may
3.The 
icon shown on the status line, indicates that the SD card is operating normally.
4.If there is a problem/error with the SD card, the Record or Playback LEDs will not light up when the Record or Play buttons are pressed. Instead, the Play, Menu, and Rec LEDs will flash quickly. Please
5.When the SD card is writing data during recording, the record LED will flash slowly.
6.After a power outage, the system
7. Tip: To quickly format the SD card, turn the DVR off. Then hold the | and |
buttons and switch the DVR on. A “Format OK” message will be displayed when the SD card is successfully formatted.
6.2. MONITORING MODE
Immediately after bootup, monitoring mode is displayed, with the following status indicators:
1.Time Display: System Date and Time.
1.
2.
3.
2. Record Status Display: Manual Record Parameter.
Record Resolution, please refer to (7.4 Record Setup) for VIDEO SIZE setup.
Record Quality, please refer to (7.4 Record Setup) for VIDEO QUALITY setup.
PI1000 | 7 |
