2-3 P/N:4809628
©2003 Paxton Automotive
All Rights Reserved, Intl.Copr. Secured
05JUN03 v2.1 MusGT(4809628 v2.1)
G. Install the supercharger rear support bracket
as shown in Fig 2-h. Temporarily install the
long 10mm bolt to line up the bracket.
Leave the bolts finger tight, as it will be
necessary to move the bracket when you
install the main supercharger bracket.
(This photo is for illustration only. You will
have to install the supercharger and acces-
sory belt before installing the bracket. There
won’t be clearance after the bracket is
installed.)
Fig. 2-h
Fig. 2-i
H. Modify the previously removed upper radia-
tor hose with supplied hose, aluminum cou-
pler and clamps. See Appendix ‘B’
(1015309) for diagram of modification.
***NOTE***
The radiator hose assembly needs to clear the super-
charger, so it is better to leave it long and trim the
assembly later than to end up short. The finished
radiator assembly is shown in Fig. 2-i.
I. Before installing the main supercharger
bracket, the A/C refrigerant refilling port
must be bent from its upright position down-
ward, so that the cap is facing the driver’s
side fender. (See Fig 2-j.)
Fig. 2-j
***NOTE***
If possible, use a proper tubing bender for this step.
If one is not available, the line can be bent by hand,
but extreme care must be taken as the refrigerant
within the line is under very high pressure. In any
case, use a pair of heavy gloves and eye protection to
prevent injury in the event of a ruptured line.