6-2
P/N:4809628
©2003 Paxton Automotive
All Rights Reserved, Intl.Copr. Secured
05JUN03 v2.1 MusGT(4809628 v2.1)
E. Remove the screen from the MAF, which
was removed in step 4.(See Fig. 6-e.)
Fig. 6-e
F. Assemble the MAF, mounting bracket,
MAF/air filter adapter and air filter. The
MAF bracket assembly may look different
from what you receive in your kit, but the
assembly procedure is the same.
G. Using the supplied 1/4-20 hardware, mount
the MAF meter to the MAF bracket and
secure. Remove the factory MAF screen
before attaching the meter to the new brack-
et.
Fig. 6-f
Fig. 6-g
H. Attach the supplied K & N air filter, 3-1/2”
sleeve, 90° 3-1/2” elbow and #56 hose
clamps to the MAF and secure.
I. Insert the factory air temperature sensor into
the rubber grommet located on the side of
the supplied 3-1/2" x 90° elbow. Lubricate
for easier fit.
***NOTE***
2002-2003 models do not have a separate IAT sen-
sor. Use the supplied elbow without ahole or grom-
met for 2002-2003 models only.
J. Using a #52 hose clamp, connect the piece
of 3-1/2” flex hose to the elbow attached to
the MAF meter and route it through the
opening in the right side inner fender toward
the supercharger. Make sure the 31/2” flex
hose does not contact or rub on the edge of
the inner fender opening. (Eventual hose
failure will result if the hose is not properly
routed.)
K. The MAF/air filter assembly will be relocat-
ed inside the passenger fender. Remove the
two nuts that secure the passenger side
bumper cover to the inner fender. (See Fig.
6-g.) Next, locate the screw at the forward,
lower edge of the passenger side wheel
opening and remove it. This will allow the
plastic inner fender to be pulled back so the
MAF/air filter assembly can be installed.
MAF BRACKET
MOUNTING LOCATION