3-1 P/N:4809628
©2003 Paxton Automotive
All Rights Reserved, Intl.Copr. Secured
05JUN03 v2.1 MusGT(4809628 v2.1)
Section 3FAN RESISTOR RELOCATION
3.1 FAN RESISTOR RELOCATION
A. Disconnect the wiring harness from the fan
resistor. (See Fig. 3-a.) Remove clips hold-
ing the fan resistor to the fan shroud. Attach
the fan resistor to the supplied bracket using
the supplied hardware.
Fig. 3-a
B. Trim the fan resistor mounting tabs on the
fan shroud to provide clearance for the air
intake assembly.(See Fig. 3-b.) The fan
shroud should look like this after trim-
ming.(See Fig. 3-c.)
Fig. 3-b
Fig. 3-c
C. Re-attach the fan resistor to the wiring har-
ness to ensure adequate wire length. (See
Fig. 3-d.) Position the fan bracket on the
passenger side of the lower fan shroud.
Mark two mounting points along the fan
shroud and drill the holes. Attach the mount-
ing bracket with the supplied hardware.
Fig. 3-d