4-1 P/N:4809628
©2003 Paxton Automotive
All Rights Reserved, Intl.Copr. Secured
05JUN03 v2.1 MusGT(4809628 v2.1)
Section 4PREPARING TO MOUNT THE SUPERCHARGER
A. Mount the main supercharger bracket,
installing the two 3/8 bolts and spacers in
the upper portion of the bracket. Install the
long 6mm bolt and spacer in the lower mid-
dle portion of the bracket, sandwiching the
A/C support between the spacer and rear
mounting bracket. Next, install the lower
most bolt and two spacers: one in between
the support and main brackets, one in
between the two brackets and the other
between the rear bracket and the cylinder
head. The small metal tab securing the
wiring harness gets sandwiched between the
cylinder head and the spacer. Leave every-
thing finger tight at this point.
***NOTE***
The drive belt, shown in this picture, should be
installed at this point.(See Fig. 4-a.)
4.1 PREPARING TO MOUNT THE SUPERCHARGER
Fig. 4-a
B. Next, install the bolt and spacer at lower
right portion of the bracket. (See Fig. 4-b.)
Go back and tighten all bolts on the mount-
ing bracket, being careful not to over torque
the small 6mm bolt. Install the supplied
drive belt as shown. (See Fig. 4-a.)
Fig. 4-b
C. Install the supercharger oil drain-back hose
on the supercharger. (See Fig. 4-c.)
***NOTE***
The hose clamp screw head should be parallel to
the supercharger mounting base.
Fig. 4-c