1-1 P/N:4809628
©2003 Paxton Automotive
All Rights Reserved, Intl.Copr. Secured
05JUN03 v2.1 MusGT(4809628 v2.1)
Section 1

INITIAL PREPARATION AND REMOVAL

B. Before the air intake assembly can be
removed, you must first disconnect the plas-
tic crankcase breather hose (A) and air idle
bypass hose (B). Unplug the air temperature
sensor (C) and mass air flow sensor (D).
(See Fig. 1-a.)
***NOTE***
(2002-2003 GT only) The air intake temperature sen-
sor is now located in the MAF. (Step “C” no longer
applies.)
Fig. 1-a

A

B

C

D

1.1 INITIAL PREPARATION AND REMOVAL
A. Begin the initial preparation and disassem-
bly process by first disconnecting the nega-
tive side of the battery, and draining one gal-
lon of coolant from the coolant reservoir. To
do this, open the valve at the bottom of the
radiator and allow to drain into a suitable
container. DO NOT allow coolant to drain
onto floor, and be sure to mop up any
coolant splatter immediately. Animals like
the taste of coolant, and if they drink it, it
will kill them.