Sylvania SRCD427P owner manual Channel Set Up, Deleting Or Adding Channels, Tv/Vcr, Make sure

CHANNEL SET UP

TV/VCR

You can program the tuner to memorize all the chan- nels you receive in your area.

NOTE: Channel memory programming is NOT needed when connected to a cable box or satellite box. Just select the TV/VCR/DVD channel to the

DELETING (OR ADDING)

CHANNEL(S)

TV/VCR

The channels you no longer receive or seldom watch can be deleted from the memory. (Of course, you can add the deleted channel into the memory again.)

output channel of the cable box or satellite box (Ex CH3), then select the channel to be viewed on the Cable Box or Satellite Box.

Make sure ...

•The unit is turned on.

1Select “CHANNEL SET UP”

Press the SETUP button on the remote control.

Press the Arrow button K or L to point to “CHANNEL SET UP”. Then press the ENTER button.

TV/VCR SETUP -

TIMER PROGRAMMING SETTING CLOCK

BCHANNEL SET UP USER’S SET UP V-CHIP SET UP LANGUAGE [ENGLISH] CAPTION [OFF] ZERO RETURN

TIME SEARCH INDEX SEARCH

1Select “CHANNEL SET UP”

Press the SETUP button on the remote control.

Press the Arrow button K or L to point to “CHANNEL SET UP”. Then press the ENTER button.

TV/VCR SETUP -

TIMER PROGRAMMING SETTING CLOCK

BCHANNEL SET UP USER’S SET UP V-CHIP SET UP LANGUAGE [ENGLISH] CAPTION [OFF] ZERO RETURN

TIME SEARCH INDEX SEARCH

2 Select “ADD/DELETE CH”	– CHANNEL SET UP –
Press the Arrow button K or L to	B ADD / DELETE CH (CATV)
point to “ADD/DELETE CH”.	AUTO CH PROGRAMMING
Press the ENTER button.

2Begin auto ch programming

Press the Arrow button K or L to point to “AUTO CH PROGRAM- MING”.

Then press the ENTER button. The tuner scans and memorizes all the active channels in your area.

– CHANNEL SET UP –

ADD / DELETE CH (CATV)

BAUTO CH PROGRAMMING

3Enter the desired channel number

Press the Arrow button K or L until your desired channel number

appears. (You can also use the	08
number buttons or the CHANNEL	ADD / DELETE

K or L button to enter it)

(Example: CH8)

• You must precede single-digit channel numbers

with a zero (Example: 02 ... 09).

3After scanning

The tuner stops on the lowest memorized channel.

•When AUTO CH PROGRAMMING is activated where there is no TV signal input, “NO TV SIG- NALS” will appear on the display after the com- pletion of the channel scanning.

•The unit may memorize TV channels as CATV channels if reception conditions are poor. If this happens, check the antenna connection and try the AUTO CH PROGRAMMING again, or wait until reception conditions are better and then try it again.

• When selecting cable channels which are higher

than 99, press the +100 button first, then press the

last two digits. (Example: to select channel 125,

first press the +100 button then press “2” and “5”).

4Delete (or add) it from (into) memory

Press the ENTER button. The channel number changes to light red. The channel is deleted from memory.

•To delete another channel, repeat steps [3] to [4].

•If you press the ENTER button again, the channel is memorized again.

Added channel: Light blue.

Deleted channel: Light red.

5Exit the channel setup mode

Press the SETUP button on the remote control to return to TV mode.

NOTE: To confirm that channel(s) has been deleted or added, press the CHANNEL K or L button.

- 18 - EN

1C29