Samsung CLX-3170 manual Getting started, Setting UP the Hardware

getting started

This chapter gives you step-by-step instructions for setting up the machine.

This chapter includes:

•Setting up the hardware

•System requirements

•Setting up the network

SETTING UP THE HARDWARE

This section shows the steps to set up the hardware which is explained in the Quick Install Guide. Make sure you read Quick Install Guide and complete following steps.

1.Select a stable location.

Select a level, stable place with adequate space for air circulation. Allow extra space to open covers and trays.

The area should be well-ventilated and away from direct sunlight or sources of heat, cold, and humidity. Do not set the machine close to the edge of your desk or table.

•Installing the software

•Using a wireless network(CLX-3175FW only)

•Machine's basic settings

3.Remove the tape holding the machine tightly.

4.Load paper.

5.Make sure that all the cables are connected to the machine.

6.Turn the machine on.

When you move the machine, do not tilt or turn it upside down. Otherwise, the inside of the machine may be contaminated by toner, which can cause damage to the machine or bad print quality.

Printing is suitable for altitudes under 1,000 m (3,281 ft). Refer to the altitude setting to optimize your printing. See "Altitude adjustment" on page 31 for more information.

Place the machine on a flat, stable surface so that there is no incline greater than 2 mm (0.08 inch). Otherwise, printing quality may be affected.

2.Unpack the machine and check all the enclosed items.

25 _Getting started